Calificación:
  • 0 voto(s) - 0 Media
  • 1
  • 2
  • 3
  • 4
  • 5
Optic-Fiber Devcie supplier
#1
Description:
The optical receiver is packaged with custom optic data link interface, integrated on a proprietary CMOS PDIC process.
The unit functions by converting optical signals into electric ones.
The unit is operated at 2.4 ~ 5.5 V and the signal output interface is TTL compatible with high performance at low power consumption.
Features:
High PD sensitivity optimized for red light
Data: NRZ signal
Low power consumption for extended battery life
Built-in threshold control for improved noise Margin
The product itself will remain within RoHS compliant version
Receiver sensitivity: up to 鈥?7dBm (Min. for 16Mbps)
Applications:
Digital Optical Data-Link
Dolby AC-3 Digital Audio Interface
Specifications:
Package: Component
Mounting: Through Hole
Type: Receiver
Length: 7.5mm
Width: 3mm
Height: 2.2mm
Typ. Dominant Wavelength: 650nm
Min. Fiber Coupling Power: -27dBm
Max. Fiber Coupling Power: -14dBm
Transmission Speed: 16Mbps
Min. Supply Voltage: 2.4V
Max. Supply Voltage: 5.5V
Min. Operating Temp.: -20C
Max. Operating Temp.: 70C
Packaging: Bag
Min. Storage Temp.: -40C
Max. Storage Temp.: 85C
Application Notes: PLR135 Series PCB layout for motherboard integration
To achieve better jitter and low input optical power performances, several PCB layout guidelines must be followed. These guidelines ensure the most reliable PLR135 POF performance for the motherboard integration. Failed to implement these PCB guidelines may affect the PLR135 jitter and low input power performances.
1. Careful decoupling of the power supplies is very important. Place a 0.1uf surface mount (size 805 or smaller) capacitor as close as (less than 2cm) to the POF Vdd and Gnd leads. The 0.1uf act as a low impedance path to ground for any stray high frequency transient noises.
2. To reduce the digital noises form the digital IC on the motherboard, the planar capacitance formed by an isolated Vcc and Gnd planes is critical. The POF device must be mounted directly on these two planes to reduce the lead parasitic inductance.   
3. The isolated Vdd and Gnd planes must be connected to the main Vcc and Gnd (digital) planes at a single point using ferrite beads. The beads are used to block the high frequency noises from the digital planes while still allowing the DC connections between the planes.Optic-Fiber Devcie supplier
website:http://www.lx-electronics.com/infrared-led/optic-fiber-devcie/
Responder


Salto de foro:


Usuarios navegando en este tema: 1 invitado(s)